AudioControl Avalon Bedienungsanleitung PDF herunterladen (Seite 2)

ARCHITECT

Model 1160/1161

Installer’s Guide

™

Appendix A

BRIDGING THE ARCHITECT

To increase the output power of the Architect, you can join

(bridge) two channels of the Architect into a single channel of 230

watts. Accomplishing this is a simple matter. Just press the Mono

button to send the same audio signal to both channels of the zone

and then connect the speaker terminals as shown in the diagram

below.

Appendices

Caution - Do not use a speaker rated at less

than 8 ohms when bridging. In a bridged

system, each channel of the bridged pair

“sees” one half of the speaker load.

This means that a bridged amp driving an

8 ohm speaker is actually operating into a 4 ohm load.

Bridged connection speaker hookup

1 2 3 4 5 6 7 ... 10 11

Keine Kommentare

AudioControl Avalon Bedienungsanleitung Seite 2