AudioControl Ten Series III Bedienungsanleitung PDF herunterladen (Seite 14)

SPECTRUM ANALYZER

Frequency Range: 400 kHz to 1 GHz

Dispersion:

Selectable from keypad, as follows:

200 kHz window - (20 kHz per division)

500 kHz window - (50 kHz per division)

1 MHz window - (100 kHz per division)

2 MHz window - (200 kHz per division)

5 MHz window - (500 kHz per division)

10 MHz window - (1 MHz per division)

20 MHz window - (2 MHz per division)*

50 MHz window - (5 MHz per division)*

100 MHz window - (10 MHz

per division)*

Dynamic Range: 60 dB

Bandwidth:

Automatically selected:

6 kHz - (100 kHz per division & below)

30 kHz - (200 kHz per division & above)

Display Range: +50 to -95 dBm

Modes: Freeze, Max Hold, Peak Hold,

Average*

Markers: Delta or Absolute Level and Frequency*

SIGNAL STRENGTH

INDICATOR

Range: 400 KHz to 1 GHz

Accuracy: ±4 dB, >3 MHz

Sensitivity: -100 dBm (antenna port rating)

WATTMETER

(RF I/O PORT)

Frequency Range: 400 KHz to 1 GHz

Measurement Range: .1 watt to 125 watts

Input Impedance: 50 ohms with maximum VSWR of 1.5:1

Accuracy: ±10%, >3 MHz

Protection: Over temperature alarms

TRACKING GENERATOR*

Frequency Range: 400 kHz to 1 GHz

Tracking Display

Sweep Range:

200 kHz window - (20 kHz per division)

500 kHz window - (50 kHz per division)

1 MHz window - (100 kHz per division)

2 MHz window - (200 kHz per division)

5 MHz window - (500 kHz per division)

10 MHz window - (1 MHz per division)

20 MHz window - (2 MHz per division)

50 MHz window - (5 MHz per division)

Display Range: 0 to -80 dBm

CABLE FAULT*

Method: Standing Wave Analysis

Measure: Fault distance, cable length

Reading: Feet and meters

Accuracy: ±10%

Metering & Measurement (Cont.)

OSCILLOSCOPE

Display Size: 6.4 in (17 cm) diagonal

Frequency

Response: 0 to 50 kHz

Vertical Input

Ranges: Selectable per the following:

10 mV, 20 mV, 50 mV, 100 mV, 200 mV,

500 mV, 1v, 2v, 5v, 10v per division

Accuracy: 5% of full scale all ranges

Sweep Ranges: Selectable per the following:

20 usec, 50 usec, 100 usec, 200 usec,

500 usec, 1 msec, 2 msec, 5 msec,

10 msec, 20 msec, 50 msec, 100 msec,

200 msec, 500 msec, 1 sec per division

Trigger: Automatic, normal, and single sweep

Markers: Delta Voltage, Delta Frequency,

Delta Period*

DIGITAL VOLTMETER

Meter Type: RMS

Frequency Range: DC plus AC of 50 Hz to 20 kHz

DC Voltage Ranges: 1.0 V, 10.0 V, 100.0 V full scale

Accuracy: 1% full scale ±1 least significant digit

AC Voltage Ranges: 1.0 V, 10.0 V, 70.0 V full scale

Accuracy: 5% full scale ±1 least significant digit

Freq. Response: 3 dB end points @ 50 Hz and 20 kHz

FREQUENCY COUNTER

Frequency Range: 5 Hz to 500 kHz plus Auto Tune

Period Counter

Range: 5 Hz to 20 kHz

Input Level: 0.1 v RMS minimum input level

Resolution: 0.1 Hz, 1 Hz and 10 Hz

varying by frequency range

Auto Tune: Monitor mode, 20 MHz to 1 GHz, unit

will scan and find signals greater than

-30 dBm

Accuracy: See TIME BASE

SINAD/DISTORTION

METER

Input Level: 0.1 V to 10 V RMS

SINAD Accuracy: ±1 dB at 12 dB SINAD

Distortion Range: 1% to 20%

Distortion Accuracy: ±0.5% of distortion or ±10% of reading

whichever is greater

Optional: C-Message Filter; CCITT Filter

w/ 600 ohm switchable load

TONE SEQUENCE

DECODE

Modulation types: PRIVATE LINE, DIGITAL PRIVATE

LINE, Single Tone, DTMF, Two-Tone

Paging, 5/6 Tone Paging, International

Select V, 20 Tone General Sequence.

Frequency Accuracy: ±3% from 300 Hz to 3 kHz

Duration Accuracy: ±12 msec for tones greater than

30 msec and 300 Hz

RS232 PORT

Bi-directional port provided with capability to respond to serial

input command vocabulary to activate standard functions and

return measured results. Baud rates to 115.2 Kbps with selectable

start, stop and parity bits.

TIME BASE: Aging .5 ppm/yr,

Temperature .05 ppm

SECURENET (Optional Feature)

Voice Testing: SECURENET compatible vocoder for

both generator and receiver provides

functional voice testing capability via

internal speaker and microphone

accessory. Scope display of voice

waveform can also be selected.

Encryption Capability: DVP-XL, DES, DES-XL, DVI-XL

For each of these algorithms, the unit

can emulate an AX, BX or CX-type key

loader to load test keys to a compatible

radio. It can accept actual keys from

Motorola external key loaders. A single

side connector is provided for key loading.

End of Message Test: The signaling tone that terminates

a SECURENET transmission can be

detected and displayed to the operator.

BER Capability: Free running, unframed V.52 pseudo

random non-encrypted sequence.

Measurement range from 0 to 20%

bit errors.

Printer/Remote

Control: RS-232 DB25 (female)

Color Monitor: Standard 15 pin VGA

AC: 100 to 130 VRMS or 200 to 260 VRMS

@ 50 Hz to 440 Hz

DC: +11 to +16 VDC (10A Fused)

Battery Option: 13.6 V, 50 minutes typical

Dimensions: 8.5” high x 16” wide x 17” deep

(21.6 cm x 40.7 cm wide x 43.2 cm)

excluding accessories, battery pack

and cover

Weight: 28.5 lbs., base unit without cover, options

or accessories

Temperature: 0° C to +50° C (operating)

-40° C to +85° C (storage)

INTERFACE PORTS

POWER & ENVIRONMENT

METERING & MEASUREMENT

*optional in R2600 and R2625; standard in R2670

1 2 ... 9 10 11 12 13 14 15 16

Kommentare zu diesen Handbüchern

Keine Kommentare

AudioControl Ten Series III Bedienungsanleitung Seite 14

Kommentare zu diesen Handbüchern